Contemporary Research ICE-HE-DXL Display Control Center with Universal Rackmount User Manual
Page 9
Page | 9
ICE-HE-DXL Display Control Center Product Manual 042021
Code
Function
Operation
Network Setup
IP=
Sets IP Address
IP=xxx.xxx.xxx.xxx Defines IP address, then returns status
IP returns the current MAC address, current IP address, subnet mask, and
gateway. Response example : $MAC=0014C810001B
IP=192.168.001.251S IG=192.168.001.001 IM=255.255.255.000 IY=1.
S or D at end of IP indicates DHCP or Static address. 000.000.000.000 indicates
DHCP, but no DHCP server detected.
IM=
Subnet Mask
IM=xxx.xxx.xxx.xxx. Defines subnet mask
IM returns the current MAC address, current IP address, subnet mask, and
gateway. Response example : $MAC=0014C810001B
IP=192.168.001.251S IG=192.168.001.001 IM=255.255.255.000 IY=1.
S or D at end of IP indicates DHCP or Static address. 000.000.000.000 indicates
DHCP, but no DHCP server detected.
IG=
Default Gateway
IG=xxx.xxx.xxx.xxx. Defines default gateway
IG returns the current MAC address, current IP address, subnet mask, and
gateway. Response example : $MAC=0014C810001B
IP=192.168.001.251S IG=192.168.001.001 IM=255.255.255.000 IY=1.
S or D at end of IP indicates DHCP or Static address. 000.000.000.000 indicates
DHCP, but no DHCP server detected.
IY=
IP Address Mode
1=Static
2=DHCP
MC
MAC Address
Returns the MAC address
IX=
Telnet Port
IX=xxxxx Defines Telnet port
Serial Communication
EN
Echo On
Echo On
This command is not available for Telnet. Enable local echo in the terminal
program.
EF
Echo Off
Echo Off
R5=
Baud Rate
1=2400
4=19.2K (Default)
2=4800
5=38.4K
3=9600
6=115.2K
Miscellaneous Commands
NW=
Set Name
Sets the ICE-HE-DXL name. Limited to 20 characters
NM
Get Name
Returns the ICE-HE-DXL name
ID
ID
Returns the product model and application firmware version
IB
Bootloader
Returns the bootloader firmware version
HR
Hardware
Returns the hardware revision
Z!
Reload factory default settings
Reconfigures unit for all factory default settings.
IP address will not revert to default until after a Z] command or power cycle.
Z]
Reboot
Emulates a reboot from a hard power cycle
I/O Port
PS=
Set Output Pin
0=Out 1 Low, Out 2 Low
1=Out 1 High, Out 2 Low
2=Out 1 Low, Out 2 High
3=Out 1 High, Out 2 High
PG
Get Input Pin Status
0=In 1 Low, In 2 Low
1=In 1 High, In 2 Low
2=In 1 Low, In 2 High
3=In 1 High, In 2 High