Marantz PM-10 Stereo 200W Power Amplifier (Black) - Manual (Page 19)

Turning off the sound temporarily
(Muting)
1
Press MUTE.
“ATT” appears on the display and the sound is muted.
0
To cancel mute, press MUTE again.
n Setting the attenuation level when
sound is muted
The attenuation level can be set at –20 dB, –40 dB, or –∞.
0
The factory default setting is –∞.
1
Press and hold MUTE for 2 seconds or longer.
The attenuation level will appear on the display.
2
Press MUTE.
The attenuation level setting value changes each time
the button is pressed.
0
If not operated for 2 seconds, the current setting is saved
and the display returns to normal.
Adjusting the left and right channel
balance
The volume level of the left and right channels can be
trimmed in 0.5 dB steps across a 0.0 － 9.0 dB range.
The factory default setting is 0.0 dB (maximum).
1
Press MODE/TRIM.
The unit enters the level adjustment mode.
0
The left channel level value flashes.
2
Use ui to adjust the left channel level.
3
Press p .
The adjustment mode selects the right channel.
0
The right channel level value flashes.
4
Use ui to adjust the right channel level.
5
Press MODE/TRIM.
The unit exits the adjustment mode.
0
If you have connected a “SLAVE” device using the
F.C.B.S. connection ( v p. 11), proceed to the
slave setting.
Having the display and the
illumination lamp off
The display circuit operation can be stopped to minimize
noise from the display and the display circuit which could
interfere with the analog audio output signal.
1
Press DISPLAY.
Each time you press DISPLAY, the display and the
illumination lamp (blue) switch on/off at the same time.
0
If you operate the VOLUME knob or another control when
the display is off, the display turns on again. When
operation is finished, the display turns off automatically
after approximately 2 seconds.
Having the illumination lamp always
off
The following procedure makes the illumination lamp always
off regardless of the display on/off operation.
1
Press and hold DISPLAY for two seconds and
longer while display is lighted.
Press and hold DISPLAY for two seconds and longer
while the lamp is always off to return to the normal
setting.
ENGLISH
18
Overview
Connections
Playback
Settings
Tips
Appendix