Marantz AV 10 Reference 15.4-Channel Home Theater Preamplifier/Processor - Manual (Page 238)

o LPF for LFE
Selects the crossover point for the LFE channel. Set this when you
want to change the playback LFE signal of the subwoofer.
80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz (Default: 120 Hz)
0
The audio settings in “IMAX Audio Settings” are applied during IMAX
playback. ( v p. 178)
o LFE Distribution
Adjusts the amount of LFE signal sent to the large floor speakers.
Off
(Default):
Floor Speakers do not play LFE signals.
–20 dB – 0 dB
Adjusts the amount of LFE signal sent to
the large floor speakers.
0
This setting cannot be set when the “Front”, “Center”, “Surround”, “Surround
Back”, and “Front Wide” settings of “Speaker Configuration” are all “Small”.
Front Speaker
Set the front speaker A/B to use for every sound mode.
A
(Default):
Front speaker A is used.
B : Front speaker B is used.
A+B : Both front speakers A and B are used.
0 This can be set when “Assign Mode” is set to “13.1ch + Front B”. ( v p. 215)
Contents Connections Playback Settings Tips Appendix
238
Front panel Display Rear panel Remote Index