11 : “sound modes and channel output, P. 306) – Marantz AV 10 Reference 15.4-Channel Home Theater Preamplifier/Processor User Manual
Page 306
z
1 The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z
2 The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z
3 The applicable sound mode includes “DTS Virtual:X” and sound modes that have “+Virtual:X” in the sound mode name.
z
4 Audio is output when “Bass” - “Subwoofer Output” in the menu is set to “LFE + Main”. (
z
5 A signal for each channel contained in an input signal is output as audio.
z
6 Audio is not output when the “Surround Parameter” - “Speaker Virtualizer” in the menu is set to “On” and “Speaker Configuration” - “Surround Back” in the menu is set to
z
7 Audio is not output when the “Surround Parameter” - “Speaker Virtualizer” is set to “On”. (
z
8 When “Speaker Configuration” - “Surround Back” is set to “2 spkrs”, “Speaker Configuration” - “Center” is set to “Large” or “Small”, and sound mode is set to “IMAX DTS”,
surround audio is output from the surround back speaker. Audio is not output from the surround speaker. (
z
9 For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in
place of Surround Height speakers.
z
10 For the best Auro-3D experience Front Height and Surround Height speakers are recommended, however you may substitute Dolby Atmos Enabled speakers.
z
11 Audio is output from the speakers specified in the “Surround Parameter” - “Speaker Select” settings. (
306