Marantz AV 10 Reference 15.4-Channel Home Theater Preamplifier/Processor User Manual
Page 275
No sound comes out of a specific speaker.
0
Check that PRE OUT cables and speaker cables are properly connected.
0
Check that a selection other than “None” is set for the “Speaker Configuration” setting in menu. (
0
Check the “Assign Mode” setting in the menu. (
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and subwoofer.
0
Audio is not output from the surround back speaker if “Speaker Virtualizer” is set to “On” when “Speaker Configuration” - “Surround Back” is set to “1
0
Audio is not output from the front wide speaker if “Speaker Virtualizer” is set to “On”. (
0
When “Speaker Configuration” - “Surround Back” is set to “2 spkrs”, “Speaker Configuration” - “Center” is set to “Large” or “Small”, and sound mode is
No sound is produced from subwoofer.
0
Check the subwoofer connections.
0
Turn on the subwoofer’s power.
0
Set “Speaker Configuration” - “Subwoofer” in the menu to “1 spkr”, “2 spkrs”, “3 spkrs” or “4 spkrs”. (
0
When “Speaker Configuration”
-
“Front” in the menu is set to “Large”, depending on the input signal and the sound mode, no sound may be output from
0
0
You can make the subwoofer always output sound by setting the “Subwoofer Output” to “LFE + Main”. (
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
275