LEICA Cine 1 100" 3000-Lumen XPR UHD 4K Ultra Short-Throw SmHome Theater Projector - Manual (Page 24)

STEP 1
ALIGN THE LOWER EDGE OF THE IMAGE HORIZONTALLY
The lower edge of the image is lower on
the left and higher on the right
▸ Turn the device anti-clockwise
The lower edge of the image is higher
on the left and lower on the right
▸ Turn the device clockwise
STEP 2
ALIGN THE LOWER EDGE OF THE PICTURE ON THE SCREEN
The image is shifted to the left
▸ Place the device slightly more to the
right
The image is shifted to the right
▸ Place the device slightly more to the left
Note
• The lower edge of the image should always remain parallel to the screen.
STEP 3
ALIGN THE LOWER EDGE OF THE IMAGE TO THE WIDTH OF THE SCREEN
The lower edge of the image is too wide
▸ Place the device closer to the screen
The lower edge of the image is too narrow
▸ Place the device further away from the
screen
Note
• The lower edge of the image should always remain parallel to the screen.
STEP 4
ALIGN THE UPPER RIGHT CORNER
You may have to repeat the following steps several times when aligning the
upper edge of the image, until both the upper and the lower edge of the image
are parallel to the screen.
The upper edge of the image is too high on the
right
▸ Turn the two levelling feet out on the right to
the same height
▸ Turn the device anti-clockwise, until the
lower edge of the image is once again parallel
to the screen
▸ Repeat the process as necessary
The upper edge of the image is too low on the
right
▸ Turn the two levelling feet in on the right to
the same height
▸ Turn the device clockwise, until the lower
edge of the image is once again parallel to
the screen
▸ Repeat the process as necessary
STEP 5
ALIGN THE UPPER LEFT CORNER
The upper edge of the image is too high on the
left
▸ Turn the two levelling feet out on the left to
the same height
▸ Turn the device clockwise, until the lower
edge of the image is once again parallel to
the screen
▸ Repeat the process as necessary
The upper edge of the image is too low on the
left
▸ Turn the two levelling feet in on the left to
the same height
▸ Turn the device anti-clockwise, until the low-
er edge of the image is once again parallel to
the screen
▸ Repeat the process as necessary