Canon EOS R6 Mark II Mirrorless Camera with 24-105mm f/4-7.1 Lens User Manual
Page 1016
The access lamp still lights or blinks even when the power switch is set
to <
>.
If the power is turned off while an image is being recorded to the card, the access lamp
will remain on or continue to blink for a few seconds. When the image recording is
complete, the power will turn off automatically.
[Battery communication error. Does this battery/do these batteries
display the Canon logo?] is displayed.
Do not use any battery packs other than a genuine Canon Battery Pack LP-E6NH/
LP-E6N/LP-E6.
Remove and install the battery again (
).
If the electrical contacts are dirty, use a soft cloth to clean them.
The battery becomes exhausted quickly.
Use a fully charged battery (
).
The battery performance may have degraded. See [ :
Battery info.
] to check the
battery recharge performance level (
). If the battery performance is poor, replace the
battery with a new one.
The number of available shots will decrease with any of the following operations:
• Pressing the shutter button halfway for a prolonged period
• Activating the AF frequently without taking a picture
• Using the lens's Image Stabilizer
• Using the wireless communication functions
The camera turns off by itself.
Auto power off is in effect. To deactivate auto power off, set [
Auto power off
] in [ :
Power saving
] to [
Disable
).
Even if [
Auto power off
] is set to [
Disable
], the screen and viewfinder will still turn off
after the camera is left idle for the time set in [
Screen off
] or [
Viewfinder off
] (although
the camera itself remains on).
1016