Olympus OM-D E-M1 Mark III Mirrorless Camera - Manual (Page 121)

121 EN
Shooting
2
Role Function
Preset MF ( PreMF )
Toggle [AF Mode] > [Preset MF] on or off (P. 64). Press the control
once to enable preset MF and again to restore the previous focus
mode. Alternatively, you can choose the [AF Mode] by holding the
control and rotating a dial.
This option will have no effect during still photography if [mode2] is
selected for [
K Fn Lever Function] (P. 219).
It will likewise have no effect during movie recording if [mode2] is
selected for [
n Fn Lever Function] (P. 163).
Lens Info Settings
( s Lens )
Recall previously-saved lens data (P. 239). Recall saved data for the
current lens after changing lenses or the like.
IS Mode ( IS )
Toggle [Image Stabilizer] on or off (P. 97). Press once to select
[Off] and again to turn image stabilization on. Hold the control and
rotate the front or rear dial to access [Image Stabilizer] options.
Flicker Scan
( P )
Adjust settings for [Flicker Scan] (P. 166, 234). Press the control
to select [On]. You can adjust shutter speed for best results while
viewing banding in the display. Press the control again to display
shooting information and access other settings. Press and hold the
control to select [Off] for [Flicker Scan].
G Lock (touch
control lock)
Lock touch controls. Press and hold the button once to lock touch
controls and again to unlock.
• This function can be assigned to the
I and G buttons only. You
must fi rst set [ d ] to [Direct Function].
Electronic Zoom
( X )
Zoom power zoom lenses in or out. After pressing the control, use the
arrow pad to zoom in or out. Use
F or I on the arrow pad to zoom
in and G or H to zoom out.
• This function can be assigned to the I and G buttons only. You
must fi rst set [ d ] to [Direct Function].
Flash Mode ( # )
Adjust fl ash settings (P. 86). Press once to display fl ash options
and again select the highlighted option and exit. Highlight settings
using the front or rear dial or
HI on the arrow pad.
• This function can be assigned to the I and G buttons only. You
must fi rst set [ d ] to [Direct Function].
• This role is available for [ K Button Function] only.