Olympus OM-D E-M1 Mark III Mirrorless Camera - Manual (Page 289)

289 EN
Cautions
6
4 Adjust fl ash settings.
• Highlight items using the FGHI buttons and rotate the rear dial to choose
settings.
Flash compensation
A Mode
P 250
1023
1:02:03 F5.6
TTL
Manual
Off
+5.0
TTL +3.0
1/8
–
Low
1 Ch
100 %
Group
Flash mode
Optical signal strength
Channel
Flash control mode
Group
Choose a group. Changes to settings apply to all units in
the selected group. Choose
Q to adjust settings for the unit
mounted on the camera.
Flash control mode Choose a fl ash mode.
Flash compensation
Adjust fl ash output. When [Manual] is selected for fl ash mode,
you can a value for manual fl ash output.
Optical signal
strength
Choose the brightness of the optical control signals emitted by
the
fl ash units. Choose [HI] if you have placed fl ash units at
close to the maximum distance from the camera. This setting
applies to all groups.
Flash mode/
fl ash level
Choose # (standard) or FP (super FP). Choose super FP for
shutter speeds faster than the fl ash sync speed. This setting
applies to all groups.
Channel
Choose the channel used for fl ash control. Change the
channel if you fi nd that other light sources in the area are
interfering with remote fl ash control.
5 Set the unit mounted on the camera to [TTL AUTO].
• Flash control settings for the FL-LM3 can only be adjusted using the camera.
 Positioning Remote Flash Units
1 Set the wireless RC fl ash units to RC mode.
• After turning compatible fl ash units on, press the MODE button and choose RC
mode.
• Choose a group for each of the compatible fl ash units using fl ash controls and match
the channel to that selected with the camera.
2 Position the fl ash units.
• Position the wireless units with the remote sensors facing the camera.
3 Take pictures after con fi rming that the remote units and the unit on the
camera are charged.