Marantz CINEMA 70s 7.2-Channel Network A/V Receiver - Manual (Page 233)

Audyssey MultEQ ® , Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® cannot be selected.
0
These cannot be selected when you have not performed Audyssey ® Setup. ( v p. 178)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. ( v p. 122)
0
These cannot be selected when sound mode is “DTS Virtual:X” or sound mode that have “+Virtual:X” in the sound mode name.
0
These cannot be selected when using the headphones.
“M-DAX” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “M-DAX” cannot be used. ( v p. 158)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. ( v p. 122)
No sound is output when using ZONE2.
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL) cannot be played back. Use analog connections.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
range of about 98.4 ft/30 m.
Sound mode settings are not available when using Bluetooth headphones. Audio menu settings are also not available.
0
This unit cannot change sound mode or audio menu settings for audio output to Bluetooth headphones.
Contents Connections Playback Settings Tips Appendix
233
Front panel Display Rear panel Remote Index