Bypass and mute – Vox StompLab IIG Modeling Guitar Effect Processor Pedal User Manual
Page 8
8
Selecting a program
1.
Check whether you are in Program select mode.
In Program select mode, the Tuner
#
LED and
LED will light
up and the EDIT LED will turn off.
When in Edit mode, the EDIT LED will light up and it will
turn off when the EDIT button is pressed to switch to Program
select mode.
2.
Select a genre with the CATEGORY selector and press the
Program UP or Program DOWN pedal to select the program.
The program/value display shows the number of the program
that you selected.
3.
Adjust the master volume as necessary.
Page 12 “Setting the type of device that you’ll be connecting
to the OUTPUT/PHONES jack and master volume - [GBL]
Expression pedal
The target function (volume, effect parameter) of the expression pedal
is set for each program. By rocking the pedal up or down during
a performance, the tone and volume will be changed accordingly.
For programs where the target function of the expression pedal is
other than volume, the target function of the effect will turn off when
the pedal is pressed strongly and the expression pedal LED will
turn off. If the pedal is pressed strongly again, the effect of the target
function will turn on and the expression pedal LED will light up.
When volume is set as the target function of the expression pedal,
volume of the program will be set according to the current position
of the pedal. For target functions other than the volume, the tone
of the program cannot be changed until the expression pedal is
used after the program is switched.
HINT:
Set the [AMP/DR] (AMP/DRIVE)LEVEL as the target
function when the volume is controlled by the expression pedal
as it is controlled by the volume pedal and when the program
volume does not change until the pedal is used after the program
is switched.
Bypass and Mute
Bypass (which turns off all effects including noise reduction)
and Mute (which mutes the StompLabs output) are convenient
functions to use while you’re adjusting your guitar amp, tuning
during a live performance, or switching guitars. Here’s how to
use Bypass or Mute.
Bypassing the StompLab
Simultaneously press the Program UP and Program DOWN
pedals; all effects will be bypassed. At this time, the program/
value display will indicate “
– –
”.
Muting the StompLab
Simultaneously press and hold down the Program UP and Program
DOWN pedals for about one second and the output will be muted.
At this time, the program/value display will indicate “
_ _
”.
When bypassed or muted, the Auto Chromatic Tuner will be
active. To cancel the bypass or mute function, press the Program
UP or Program DOWN pedal (this will not change the program).