Furuno FSV-84 - Manual (Page 17)

1-9
Mounting procedure
1. Drill four holes of 12 mm in diameter in the mounting location, referring to the outline
drawing for mounting dimensions.
2. Unfasten two M4×10 screws to dismount the front cover.
3. Unfasten two sets of M10 bolts, plain washers and spring washers to separate the
monitor from the mounting base.
4. Pull the monitor forward about 4 cm and then lift it to separate it from the mounting base.
5. Fasten the mounting base to the mounting location with M10 bolts, nuts and washers
(local supply).
6. Lay the monitor on the top of the mounting base, mating the rear pin on the monitor to
the slit in the mounting base. Fix the monitor to the mounting base with the two sets of
bolts, nuts and washers unfastened at step 3.
7. Close the front cover.
Front Cover
Pan-Head Screw
M4x10, 2 pcs.
Hex Bolt
M10x30,
2 pcs.
Spring Washer, M10, 2 pcs.
Plain Washer, M10, 2 pcs.
Mounting Base
Hex Bolt
M10, 4 pcs.
Washer
Pin
Slit
Monitor unit