Marathon MAGNUM ROUTER - Manual (Page 58)

Chapter 7: Magnum Router GUI Manager
___________________________________________________________________
7-13
Adding a WAN IP Route Map Entry
To add an entry in the WAN IP Route Map screen, perform the following steps:
1. Click New Entry and select the Ethernet 1 port
2. Enter the appropriate private DLCI number, destination network IP address and subnet
mask and corresponding gateway (a.k.a. next hop IP address)
3. Click Save Edit or press ALT-V to save the entry
4. Click Exit Edit or press ALT-X to return to the WAN IP Route Map screen.
All entries in the WAN IP Route Map are automatically written to the Advanced Routing table as
well. The Advanced Routing section is covered later in this section.
Changing a WAN-IP Route Map Entry
It is possible to change an entry after it has been entered into the table. Follow these steps to
change an entry:
1. Double-Click on the entry that needs modification in the table
This will cause all of the entry data to be loaded in the fields above the table.
2. Make any modifications required
3. Click on Save Edit or press ALT-V
4. Click on Exit Edit or press ALT-X
If this entry was selected by mistake and is not the one that needed modification, just click on
the Exit Edit or press ALT-X.
Deleting a WAN-IP Route Map Entry
In some cases, an entry may need to be deleted. To do this, follow these steps:
1. Select an entry in the table.
2. Either click the Delete Entry button or press ALT-D.
3. A verification question is asked to make sure that this is the entry to delete, if it is, select
Yes. Selecting No will return to the WAN-IP Route Map screen.
Repeat for each entry that is to be deleted.
If there is no need to add additional routes to the Magnum Router, click on Save or press ALT-V
to save any changes, then click on Exit, or press ALT-X to return to the WAN Configuration
screen.