Marathon MAGNUM ROUTER - Manual (Page 62)

Chapter 7: Magnum Router GUI Manager
___________________________________________________________________
7-17
Adding an Ethernet IP Entry
To add an entry in the Ethernet IP screen, perform the following steps:
1. Click New Entry or press ALT-N
2. Enter data in the IP Address and Subnet Mask fields
3. Click Save Edit or press ALT-V
4. Click Exit Edit or press ALT-X
Changing an Ethernet IP Entry
It is possible to change an entry after it has been entered into the table. Follow these steps to
change an entry:
1. Double-Click on the entry that needs modification in the table
This will cause all of the entry data to be loaded in the fields above the table.
2. Make any modifications required
3. Click on Save Edit or press ALT-V
4. Clock on Exit Edit or press ALT-X
If this entry was selected by mistake and is not the one that needed modification, just click on
the Exit Edit or press ALT-X.
Deleting an Ethernet IP Entry
In some cases, an entry may need to be deleted. To do this, follow these steps:
1. Select an entry in the table.
2. Either click the Delete Entry button or press ALT-D.
3. A verification question is asked to make sure that this is the entry to delete, if it
is, select Yes. Selecting No will return to the Ethernet IP address screen.
Repeat for each entry that is to be deleted.