Integra CROMA24 - Manual (Page 107)

Assembly\Disassembly 107
ASSEMBL
Y/
DISASSEMBL
Y
Croma24 Service Manual
8. Using a #2 Phillips screwdriver, remove the three screws and
washers securing the Trailing Cable Cover Assembly to the C-
Bracket Assembly. See Figure 5-10.
9. With the Carrier Assembly in the far right position (if still
installed), carefully slide the Trailing Cable Cover left until it
clears the back of the Carrier Assembly. Then lift the Trailing
Cable Assembly out of the printer.
Install the Trailing Cable Cover Assembly
1. Ensure that the Carrier Assembly (if installed) is at the far
right side of the Slide Shaft, position the Trailing Cable Support
Assembly in front of the C-Bracket and offset to the left enough
to clear the Carrier Assembly.
2. Carefully slide the right side of the Trailing Cable Cover
Assembly behind the Carrier Assembly until the screw holes on
the Trailing Cable Cover Assembly lines up with the holes in the
C-Bracket Assembly.
3. Fasten the Trailing Cable Cover Assembly onto the C-Bracket
Assembly with 3 screws with 15 in-lb of torque.
4. Insert the right side of the Trailing Cable through the hole
provided in the Platen and Secure to the J6 connector on the
MPCB.
5. If the Carrier Assembly is not installed, perform steps 5
through 18 of the Reinstalling the Carrier Assembly, Carrier
Belt, and the Frame Tensioner procedures.
6. Push the Trailing Cable up through the opening in the Strain
Relief.
7. Fold the Trailing Cable and press it down onto the tape.
8. Slide the fold in the Trailing Cable under the triangular portion
of the Strain Relief.
9. Slide the Ferrite Bracket onto the Strain Relief until the catch
is securely in place on the Strain Relief.