Integra CROMA24 - Manual (Page 87)

5
ASSEMBL
Y/
DISASSEMBL
Y
87
Assembly\Disassembly
Introduction
Chapter 5 contains the procedures for removal and replacement of
the Croma24 printer assemblies and mechanisms. Illustrations are
provided for clarity. Steps for each replaceable part may depend
on parts already removed in previous disassembly directions. It is
recommended that you read through each procedure before begin-
ning the removal and replacement of any assemblies or mecha-
nisms.
The following is a list of tools which are recommended to disassemble
and reassemble the printer:
l #1 Phillips Torque Screwdriver
l #2 Phillips Torque Screwdriver
l
#1 Slotted Torque Screwdriver
l #2 Slotted Torque Screwdriver
l #1 Phillips Screwdriver
l #2 Phillips Screwdriver
l
#1 Slotted Screwdriver
l #2 Slotted Screwdriver
l Torque Screwdriver, Allen Hex Driver (4mm)
l
Torque Screwdriver, Socket Head (4mm)
l Wire Cutters
l Needle Nose Pliers
l
X-ACTO Knife
l ESD Wrist Strap
The following materials are also required:
l Isopropyl Alcohol
l Cotton Swabs
l Lint Free Cloth or Tissue
l Double Sided Tape (1/16” thick, 3/4” wide)
l Loctite Blackmax, P/N 200172
A Hardware Kit is available for the printers. See Chapter 6 of this
manual for the part number.