Sanyo DSR-3706PA - Manual (Page 12)

English
Names and functions of parts (rear panel)
11 Foreword
Use Category 5 10BASE-T/100BASE-TX LAN cables.
A Connecting directly to a PC (without using a hub)
B Connecting to the intranet (using a hub)
Alarm and RS-485 connections
Network connection terminals (LAN)
USB LAN TERMINATE RS-485
OFF ON
A RS-485 B
ALARM IN
AC IN
SENSOR
ALARM OUT
C
CLO CK IN
CLO CK O
UT
ALARM OUT ALARM RESET ALARM FULL NON REC OUT WARNING OUT
FULL
SERIES OUT EXIT TIMER IN SERIES IN
REMOTE
CONTROL
C 1 2 3 4 5 6
C 1 2 3 4 5 6
C R1 R2
1
IN
OUT
ALL RESET
AUDIO
MON2 MIC IN IN OUT
2 3 4 5 6
MAIN
POWER MODE AUTO MENU
1
6
1 Alarm input terminals (ALARM IN)
Connecting a switch or security sensor etc. to the terminal of the
DVR allows the detection of the intrusion of outsiders when doors
etc. are opened and closed.
Alarm input settings are necessary. (P55)
External switch
connected to the
alarm input terminal
2 Sensor alarm output terminals
(SENSOR ALARM OUT)
This terminal is used to output the signals listed below
whenever the motion sensor of the digital video recorder is
triggered. This output terminal can be used for a warning light
by connecting a lamp to it.
Motion sensor settings are necessary. (P58)
Rating for each terminal:
• Maximum current: 25mA
• Maximum voltage: DC 25V
RS-485 connection (P70)
Power
POWER MODE AUTO MENU
1 – 6
Cross type
PC
POWER MODE AUTO MENU
1 – 6
PC
PC
Switching hub
Switching hub
Intranet
Straight type