Sanyo DSR-3706PA - Manual (Page 59)

English
Recording settings
How to set 58
Use this screen for motion sensor setting on a live video
screen to detect moving objects such as intruders, and
generate alarms.
The motion sensor detects movement based on
intensity-changes on the screen. It is necessary to use
sensor settings that are appropriate for both the location
of the sensor and for the observed objects.
1 Cursor
The default location of the cursor is the upper left corner.
Use the J-dial to move it horizontally.
2 Sensor setting range
The motion sensor can be set within this area.
3 Motion sensor
The type of sensor can be selected according to the
detection location. Use the J-dial to change the type of the
sensor.
–: Sensor turned off
A: Sensor A is used for detection
B: Sensor B is used for detection
4 Camera number display (CH01)
Selects the camera number for the motion sensor.
Use the camera selection buttons to change the camera
number.
Selections: CH01/CH02/CH03/CH04/CH05/CH06
5 Time period (T-1)
This DVR has two timers (A and B) for setting time periods
in two blocks, and separate sensors can be set up for each
period.
Refer to the section about setting the time periods. (P37)
Selections: T-1/T-2/T-3/T-4
6 LEVEL
Sets the sensitivity of the motion sensor.
OFF: Sensitivity is not set.
1 (High sensitivity) ~ 10:
Selects the sensitivity as a numeric value.
☞
Motion sensor sensitivity check
When the sensor detects movement, the green ( ) symbol
changes to red, and a buzzer (beeper) goes off.
If the sensitivity is set high, a slight change in the lighting
may trigger the sensor. Set the sensitivity appropriate for
the setting location.
☞
Stopping the motion sensor recording
Display the <ALARM REC MODE SET> screen while
recording is in progress, and turn the S-dial clockwise.
The motion sensor screen appears. Press the camera
selection button of the current camera, and set LEVEL
"OFF".
7 MODE
Sets the detection method of the motion sensor.
Selections:
A: Detects moving objects at the location.
B: Detects moving objects at the location.
A AND B:
Detects simultaneous movement of objects at location
A and B.
A AND NB:
Setting the moving objects detection to A and the
non-moving objects detection to B will ensure that only
A detects moving objects so that the detectors do not
respond to such changes as light changes detected
simultaneously.
A TO B:
Detects objects moving from location A to location B
(time from A to B is within 2 seconds).
B TO A:
Detects objects moving from location B to location A
(time from B to A is within 2 seconds).
C: Detects when the intensity on the entire screen
becomes even (for example vandals spray-painting the
camera). There is no need to set a location for the
sensor.
G-4 Motion sensor screen description
1
2
3
4 5 6 7
CH01 T-1 LEVEL : OFF MODE : A
<TIME PERIOD SET>
TIME PERIOD T-1 T-2 T-3 T-4
TIME PERIOD A 00:00 00:00 00:00 00:00
TIME PERIOD B 00:00 00:00 00:00 00:00
SELECT TIME PERIOD
SEQUENCE TIME PERIOD A
MASK TIME PERIOD A
MOTION SENSOR TIME PERIOD A