Tektronix Phaser 600 - Manual (Page 60)

I N S T A L L I N G T H E S T A R T E R P A P E R R O L L
4 4
3 With the paper roll cover open,
use the guide on the right side of
the printer to ensure that the
paper enters straight.
4 Holding the paper by the outside
edges, guide the paper evenly
into the slot between the top
cover and printer body until it
stops (about two or three inches)
and buckles slightly.
5 The printer picks the paper and
advances it, and the front panel displays a series of messages (
Loading... ;
Unloading... ); when the media is successfully loaded, the Ready
message appears.
N O T E
The printer advances the paper to measure the paper and calibrate for its width
(
Loading... ). Once the paper is measured, the printer reverses the paper
( Unloading... ) so that it is aligned and ready to print.
4
9480-72
3