Tektronix Phaser 600 User Manual
Page 627
S
Y M P T O M S
A N D
S O L U T I O N S
6 1 0
Print job does
not finish (the
printer times out)
If you are using the serial or parallel port from a PC, make sure that you used
the
MODE
command to set the PC’s communication parameters. For
example:
MODE LPT1:,,P > NUL
MODE COM1:9600,N,8,1,P
The
P
parameter in these commands sets the port timeout to
Infinite Retry
and must be part of the command.
If you are using Windows 3.1 or Windows 95, make sure that the
Transmission Retry
value for the printer’s assigned port is set to
950
. For
more information, see
Error indicator is
blinking
The
Error
indicator blinks with any hard error, such as media jam or door
open.
Look at the front panel for an indication of the type of error, then correct the
problem. If the front panel message is
Service Required/Fault Code:xx
, make note
of the fault code number, then turn the printer off and on again. If the
Error
indicator remains on after power-up, your printer requires service. See
for telephone information.
If you can’t make a print (cont'd.)
Symptom
Solution