Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 104)

Chapter 8
SpeedTouch™ Remote Access
E-DOC-CTC-20051017-0155 v1.0 94
Configuration via
CLI commands
To have SSH access via WAN, additional configuration of the SSH service is needed.
Use the following CLI command to allow SSH access from the WAN to the
SpeedTouch™:
If you take a look at the SSH service configuration, you will see that the wan group
is added to the Interface Access List:
=>:service system ifadd name=SSH group=wan
=>:service system list name=SSH expand=enabled
Idx Name Protocol SrcPort DstPort Group
----------------------------------------------------------------------
1 SSH tcp 22
Description................ SSH server
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log
User Managed Attributes.... state aclip aclif aclifgroup map log
Attribute Values :
State...................... enabled
Port....................... 22
Ip Access List............. any
Interface Access List...... any
Interface Group Access List lan wan
Map List................... 22
Logging.................... disabled