Technicolor - Thomson Wireless Business DSL Routers SpeedTouchTM620 - Manual (Page 197)

Chapter 11
SpeedTouch™ Advanced Diagnostics
E-DOC-CTC-20051017-0155 v1.0 187
IP Diagnostics There are two useful commands:
 ping: Send IGMP ECHO_REQUEST packets to a given destination
 traceroute: Send ICMP/UDP packets to trace the ip path.
Each of these can be given from the root of the CLI, as well as from any other place
in any command group.
The Ping Command The Ping command has the following syntax:
It uses the following parameters:
Example
Below is an example of a ping command and its reply:
ping addr = <ip-address>
[count = <number{1-1000000}>]
[size = <number{0-20000}>]
[interval = <number{100-1000000}>]
[listen = <{disabled|enabled}>]
[dffield = <{disabled|enabled}>]
[srcaddr = <ip-address>]
Parameter Value Description
addr <ip-address> The destination IP address.
count <number{1-1000000}> The number of pings to send.
size <number{0-20000}> The size of the ping payload(s).
interval <number{100-1000000} The interval in milliseconds between
packets.
listen <{disabled|enabled}> Don't send, just listen for incoming
ICMP packets.
dffield <{disabled|enabled}> Enables setting of the don't fragment
flag in the IP headers of the ping
srcadr <ip-address> The IP source address to use.
{Administrator}=>ping addr 192.168.1.60
40 bytes from 192.168.1.60: icmp_id = 2, icmp_seq=0 time=962 us
40 bytes from 192.168.1.60: icmp_id = 2, icmp_seq=1 time=866 us
40 bytes from 192.168.1.60: icmp_id = 2, icmp_seq=2 time=757 us
40 bytes from 192.168.1.60: icmp_id = 2, icmp_seq=3 time=742 us
40 bytes from 192.168.1.60: icmp_id = 2, icmp_seq=4 time=753 us