ZyXEL Communications NBG-419N - Manual (Page 88)

Chapter 9 WISP Mode
NBG-419N User’s Guide
88
9.5.3 Advance Screen
Use this screen to enable the power saving mode of your NBG-419N. Go to
Configuration > Wireless LAN to open the following screen.
Figure 56 Configuration > Wireless LAN > Advance Screen (WISP)
The following table describes the labels in this screen.
Table 34 Configuration > Wireless LAN > Advance Screen (WISP)
LABEL DESCRIPTION
Power
Saving Mode Select CAM (Constantly Awake Mode) if you do not want your NBG-
419N to go to “sleep” when no wireless activity is detected in the Wireless
LAN.
Select Power Saving Mode if you want the NBG-419N to go to sleep
when no wireless connection is needed for a period of time. This means
the NBG-419N consumes less electrical power.
RTS
Threshold This is the maximum data fragment size that can be sent in a wireless
network before the AP fragments the packet into smaller data frames.
Fragment
Threshold This value controls how often wireless clients must get permission to send
information to the AP. The lower the value, the more often the wireless
clients must get permission. If this value is greater than the fragmentation
threshold value, then wireless clients never have to get permission to send
information to the AP.
Apply Click Apply to save your changes back to the NBG-419N.
Reset Click Reset to reload the previous configuration for this screen.