Armasight NSMNYX14P1F6DA1 NYX-14 Pro FLAG Night Vision Monocular - Manual (Page 23)

23
3. To attach the Nyx-14 PRO to the adapter bracket (B), push down on the button (C), loosen the fixing
screw (D), and insert the unit rail into the bracket guide. Tighten the screw (D) to secure the Nyx-14 PRO
to the bracket.
4. Insert the daytime riflescope eyepiece into the adapter (now attached to the Nyx-14 PRO). Be sure to
leave a small space between the riflescope eyepiece and the monocular’s front lens.
5. Tighten the adapter fixing screw (A).
6. To work solely with the daytime scope, push down on the button (E) and flip the Nyx-14 PRO over
(180º).
D
B C
FIGURE 3-6. MOUNTING THE NYX-14 PRO TO A SCOPE
E
A
3.1.7 MOUNTING THE NYX-14 PRO TO A DUAL BRIDGE
To install two Nyx-14 PRO units onto a single binocular device, use the optional dual bridge. Perform
the following steps:
1. Align the Nyx-14 PRO with the dual bridge (A).
2. Press down on the clamps (B) that are located on the front of the bridge.
3. Pull the unit back until the alignment boss is lined up against the groove (C) of the dual bridge. Push
the unit back until it is securely fixed to the dual bridge.
4. Perform steps 1-3 with the second Nyx-14 PRO unit.
To remove the Nyx-14 PRO from the dual bridge, press down on the front clamps and slide the unit
forward.
To configure the Nyx-14 PRO for long-range observation with binoculars, mount the 3x accessory lens-
es to the units as seen in Part 3.1.10 of this Manual.
To mount the dual bridge to the optional goggle kit, see Part 3.1.2 of this Manual.
C
B
A
FIGURE 3-7. MOUNTING THE NYX-14 PRO TO A DUAL BRIDGE