Set atm-link (enable | disable), Command mode, Description – Avaya Cajun P880 User Manual
Page 22: Syntax, Sample output
1-12
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set atm-link (enable | disable)
Command Mode
Configuration
Description
Enable or disable an ATM link. Disabling an ATM Link effectively
blocks traffic to/from the remote destination. If you are using a
Replicating VSP, disabling a single ATM Link allows traffic to flow to
other destinations while blocking traffic from the disabled link’s
destination.
You must also disable an ATM Link when you are going to make
changes to the link’s parameters.
Syntax
set atm-link <link-name> {enable | disable}
Table 1-9. Arguments, Parameters, Keywords
Sample Output
The following example enables ATM Link TestLink:
ATM(configure)# set atm-link TestLink enable
ATM Link TestLink has been enabled!
Name
Definition
link-name
The name of the ATM link you will enable or
disable.
Use th
e show atm-link <vsportId> [<link-
id>]
to get the name of an ATM-Link whose
name is greater than 10 characters.
enable | disable
Enables or disables the atm link.