Avaya Cajun P880 - Manual (Page 32)

1-22
Chapter 1
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
set network pnni-level
Command Mode
Configuration
Description
Set the Private Network-to-Network Interface (PNNI) level. This
command is only used when Multiport is set to Yes. See the
command
“set network multiport” on page 21
* Note: You must disable a network each time you make a
change to the configuration. After you make
configuration changes, you must enable the network in
order for the changes to take effect.
Syntax
set network pnni-level <pnni-level>
Table 1-17. Parameters, Keywords, Arguments
Sample Output
This example sets the PNNI level to 96.
ATM(configure)# set network disable
Network has been disabled
ATM(configure)# set network pnni-level 96
PNNI Level 96 set successfully
ATM(configure)# set network enable
Network has been enabled
Name Definition
pnni-level The value of the PNNI level. The range of values
is: Minimum = 8, Maximum = 104. The values
must be multiples of 8.