Teledyne LeCroy Summit T24 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 92)

Teledyne LeCroy Properties Dialog Boxes for Events
80 Summit T24 PCI Express Multi‐Lane Protocol Analyzer User Manual
5.21.13 NVME Command Completion Properties Dialog
The NVME Command Completion Properties dialog allows you to change the pattern and
customize it by defining each specific bit as shown in the figure below.
Figure 5.38: NVME Command Completion Properties Dialog
5.21.14 Actions Properties Dialog
Every Event has an Action tab as shown in Figure 5.39 on page 81 .
The following tables describes the Actions for each Event.
TABLE 5.4: Event Actions
Action Description
Label Label the action.
Channels Select Channels to go upstream or downstream.
Internal Triggering Check the box to enable Internal Triggering. For Trigger In
from MicroD cable (see
“MicroD to CATC Sync Cable” on
page 17 ).
External Triggering Set the External Triggering to Low, High or Toggle. The
default is None. For Trigger Out from MicroD cable
(see
“MicroD to CATC Sync Cable” on page 17 ).
Sequence Set the Sequence to Advance. The default is None.
Filtering Set the Filtering to Filter Out. You cannot Filter In in the
Summit Z3‐16. The default is None.
Local Timer Set the Local Timer, there are four options available.
Action You can set the Action of the timer to Start or Reset.
When you reset the timer it resets to it’s initial value. The
default is No Action.