Watlow Series F4S/D - Manual (Page 16)

Main Page Parameter Table
Modbus
Register
Range read/write Conditions for
Parameter Description (Modbus Value) Default [I/O, Set, Ch] Parameters to Appear
Go to Factory
Set security settings,
and calibrate and re-
store factory settings.
Go to Setup
Set up inputs and
outputs, configure
the system and
design the Main
Page.
Go to Profiles
Create, edit, delete
and rename profiles.
Go to Operations
Auto-tune PID sets,
edit PID parameters
and select alarm set
points.
*Digital outputs configured as
events can be turned on/off in the
static set point mode or when a
running profile is on hold. The
event output status will remain as
set until reset by the profile or by
the operator.
Current File
Current Step
Input 2 value
Set Point 1
Set Point 2
Step Type
Target SP1
Target SP2
Wait for
Status
Time
Remaining
Digital Ins
Digital Outs*
% Power 1
% Power 2
Date
Time
None
Input 1 Value
Input 2 Value
Input 3 Value
Set Point 1
Set Point 2
% Power 1
% Power 2
Tune status 1
Tune status 2
Time
Date
Digital Ins
Digital Outs
Time Remaining
Current File
Current Step
Active Ch1 PID Set
Active Ch2 PID Set
Last Jump Step
Jump Count
WaitFor Status
Step Type
Target SP1
Target SP2
Inner Set Point
Custom Message 1
Custom Message 2
Custom Message 3
Custom Message 4
Input 1 Cal. Offset
Input 2 Cal. Offset
Input 3 Cal. Offset
Parameter x (1 to 16)
View customized
parameter list.
Autotuning Channel x (1 or 2)
Alarm x (1 to 2) Condition
Input x (1 to 3) Error
Main > Setup > Main Page
Main Page
2 . 8 ■ K e y s , D i s p l a y s a n d N a v i g a t i o n Wa t l o w S e r i e s F 4 S / D