West Control Solutions N8800 User Manual
Process controller 8800
Advertising
Table of contents
Document Outline
- Contents
- 1 Mounting 6
- 2 Electrical connections 7
- 3 Operation 12
- 3.1 Front view 12
- 3.2 Behaviour after power-on 13
- 3.3 Operating level 13
- 3.4 Error list / Mainenance manager 14
- 3.5 Self-tuning 17
- 3.5.1 Preparation for self-tuning 17
- 3.5.2 Optimization after start-up or at the set-point 18
- 3.5.3 Selecting the method ( ConF / Cntr / tunE ) 18
- 3.5.4 Self-tuning start 22
- 3.5.5 Self-tuning cancellation 22
- 3.5.6 Acknowledgement procedures in case of unsuccessful self-tuning 23
- 3.5.7 Examples for self-tuning attempts 24
- 3.6 Manual self-tuning 25
- 3.7 Second PID parameter set 26
- 3.8 Alarm handling 27
- 3.9 Operating structure 29
- 4 Configuration level 30
- 4.1 Configuration survey 30
- 4.2 Configuration parameters 31
- 4.3 Set-point processing 49
- 4.4 Switching behaviuor 50
- 4.5 Configuration examples 53
- 4.5.1 On-Off controller / Signaller (inverse) 53
- 4.5.2 2-point controller (inverse) 54
- 4.5.3 3-point controller (relay & relay) 55
- 4.5.4 3-point stepping controller (relay & relay) 56
- 4.5.5 Continuous controller (inverse) 57
- 4.5.6 D - Y - Off controller / 2-point controller with pre-contact 58
- 4.5.7 8800 process controller with measured value output 59
- 4.5.8 Continuous controller with integrated positioner ( Cntr/ C.Fnc = 6 ) 60
- 5 Parameter setting level 61
- 6 Calibration level 67
- 7 Special functions 70
- 8 8800/8840 configurator 76
- 9 Versions 77
- 10 Technical data 78
- 11 Safety hints 81
- 12 Notes 83
- Index
- 0-9
- A
- B
- E
- F
- I
- L
- M
- N
- O
- P
- R
- S
- T