West Control Solutions N8800 - Manual (Page 47)

g
Resetting the controller configuration to factory setting (Default)
r chapter 11.1 (page 82)
+ 8800/8840 configurator - the engineering tool for the West controller series
3 engineering tools with different functionality facilitating 8800 process
controller configuration and parameter setting are available (see chapter 9:
Accessory equipment with ordering information).
In addition to configuration and parameter setting, 8800/8840 configurator is
used for data acquisition and offers long-term storage and print functions.
8800/8840 configurator is connected to 8800 process controller via the
front-panel interface by means of PC (Windows 95 / 98 / NT) and a PC adaptor.
Description 8800/8840 configurator: see chapter 8: 8800/8840 configurator
(page 74).
Configuration level
8800 process controller 47 Configuration parameters
Lin
(only visible with 8800/8840 configurator
Name Value range Description Default
Lin Linearization for inputs INP1 or INP3
Access to this table is always with selection special
thermocouple for InP.1 or InP.3or with setting
S.Lin = 1: special linearization for linearization.
Default: KTY 11-6 (0...4,5 kOhm)
In.1
-999.0..99999 Input value 1
The signal is in [µV] or in [[] dependent of input type
1036
Ou.1 0,001...9999 Output value 1
Signal assigned to In.1
-49,94
In.2 -999.0..99999 Input value 2
The signal is in [µV] or in [[] dependent of input type
1150
Ou.2 0,001...9999 Output value 2
Signal assigned to In.2
-38,94
:
:
:
:
:
:
:
:
In.16
-999.0..99999 Input value 16
The signal is in [µV] or in [[] dependent of input type
4470
Ou.16 0,001...9999 Output value 1 6
Signal assigned to In.16
150,0