Innotech iSEA User Manual
Page 26
Innotech Service & Event Analyser Installation Instructions
Page 26
© Mass Electronics Pty Ltd 2011
Edition 3.1 dated 26.03.2014
2. In the General tab, set the Connection name to ‘iSEA Monitoring’, the Address to the
computer name or IP address of the computer running iSEA, and the Port to 21001.
3. In the Network tab, set the Address of the first device to 1, and the Address of the last device
to 2.
4. Click the Ok button to confirm the settings as shown below in Figure 3-9.
5. Two devices will be listed under the connection if the settings are correct and iSEA is
running. The first device will have the device name ‘iSEA’, and its Status will be Alive when
the connection to iSEA is successful. Two blocks will be loaded for this device.
Figure 3-8: iComm TCP Connection General Properties
Figure 3-9: iComm TCP Connection Network Properties
Figure 3-10: Devices in iSEA Connection
If Process Monitoring is disabled for certain products, they will no longer show in iComm or have a device address
on the network.
IMPORTANT