HP Brocade 4Gb SAN Switch for HP BladeSystem p-Class - Manual (Page 26)

26 Performing basic configuration tasks
10. Activate and verify the license as follows:
a. Connect to the switch and log in as admin.
b. Activate the license using the licenseadd command. For example:
switch:admin> licenseadd “key”
The license key is case sensitive and must be entered exactly as given. The quotation marks
are optional.
For the Core Switch 2/64 and SAN Director 2/128, the licenses are effective on both CPs and on
all logical switches.
c. Verify that the license was added by issuing the
licenseshow
command. The licensed features
currently installed on the switch are listed. If the feature is not listed, issue the
licenseadd
command again.
d. Some features may require additional configuration , or you might need to disable and reenable
the switch to make them operational; see the feature documentation for details.
Example
To remove a licensed feature:
1. Connect to the switch and log in as admin.
2. Issue the
licenseshow
command to display the active licenses.
3. Remove the license key using the
licenseremove
command. For example:
switch:admin> licenseremove “key”
The license key is case sensitive and must be entered exactly as given. The quotation marks
are optional.
After removing a license key, the optionally licensed feature is disabled when the switch is rebooted
or when a switch disable or enable is performed. For the Core Switch 2/64 and SAN Director
2/128, reboot both the primary and the secondary CP cards to ensure that HA features remain
synchronized.
4. Issue the
licenseshow
command to verify that the license is disabled.
switch:admin> licenseshow
SbeSdQdQySyriTeJ:
Web license
Zoning license
Fabric license
Remote Switch license
Extended Fabric license
Fabric Watch license
Performance Monitor license
Trunking license
Security license
SbbebdQS9QTscfcB:
Ports on Demand license - additional 8 port upgrade
SbbebdQS9QTcgfcz:
Ports on Demand license - additional 8 port upgrade