Using legacy commands for snmpv1 – HP Brocade 4Gb SAN Switch for HP BladeSystem p-Class User Manual
Page 64
64
Configuring standard security features
To display the mibCapability configuration, use the following as an example:
To change the systemGroup configuration to default, use the following as an example:
Using legacy commands for SNMPv1
Use the
snmpconfig
command to configure the SNMPv1 agent and traps (see ”
” on page 61). However, if necessary for backward compatibility, you can choose to use
legacy commands.
switch:admin> snmpconfig --show mibCapability
FA-MIB: YES
FICON-MIB: YES
HA-MIB: YES
SW-TRAP: YES
swFCPortScn: YES
swEventTrap: YES
swFabricWatchTrap: YES
swTrackChangesTrap: NO
FA-TRAP: YES
connUnitStatusChange: YES
connUnitEventTrap: NO
connUnitSensorStatusChange: YES
connUnitPortStatusChange: YES
SW-EXTTRAP: NO
FICON-TRAP: NO
HA-TRAP: YES
fruStatusChanged: YES
cpStatusChanged: YES
fruHistoryTrap: NO
switch:admin> snmpconfig --default systemGroup
*****
This command will reset the agent's system group configuration back
to factory default
*****
sysDescr = Fibre Channel Switch
sysLocation = End User Premise
sysContact = Field Support
authTraps = 0 (OFF)
*****
Are you sure? (yes, y, no, n): [no] y