HP Photosmart 3110 All-in-One Printer - Manual (Page 98)

Receive a fax manually
If you set up your HP All-in-One to receive faxes manually (the Auto Answer option is
set to Off ) or you answer the phone and hear fax tones, use the instructions in this
section to receive faxes.
1.
Make sure the HP All-in-One is turned on and you have paper loaded in the main
tray.
2. If you are currently on the phone with the sender, instruct the sender to press
Start on their fax machine.
3. When you hear fax tones from a sending fax machine, do the following:
a.
Press the Fax button on the control panel of your HP All-in-One.
b. Press until Receive Fax Manually is highlighted, and then press OK .
c. Press Start Black or Start Color .
d. After the HP All-in-One begins to receive the fax, you can hang up the phone.
Tip If the phone you are using is on the same phone line as your HP All-
in-One, but is not plugged into the "2–EXT" port on the back of the HP All-
in-One, you might not be close enough to your HP All-in-One to reach the
control panel. If you cannot reach the control panel, wait several seconds,
and then press 1 2 3 on your phone.
If the HP All-in-One does not begin receiving the fax, wait several more
seconds and press 1 2 3 again. After the HP All-in-One begins to receive
the fax, you can hang up the phone.
Set up backup fax reception
Depending on your preference and security requirements, you can set up the HP All-
in-One to store all the faxes it receives, only the faxes it receives while the device is in
an error condition, or none of the faxes it receives.
Note The HP All-in-One deletes all the faxes stored in its memory when you
turn off the HP All-in-One. You can also delete the faxes from memory by
clearing the fax log from the
Setup Menu , or changing the Backup Fax
Reception mode to Off . For more information, see the onscreen HP Image
Zone Help .
The following Backup Fax Reception modes are available: On , On Error Only , and
Off .
● On is the default setting. When Backup Fax Reception is On , the HP All-in-One
stores all faxes it receives in memory. This enables you to reprint up to eight of
the most recently printed faxes if they are still saved in memory. For more
information, see
Reprint received faxes from memory .
Note After the memory becomes full, the HP All-in-One overwrites the
oldest, printed faxes as it receives new faxes. If the memory becomes full
of unprinted faxes, the HP All-in-One will stop answering incoming fax calls.
● On Error Only causes the HP All-in-One to store faxes in memory only if there is
an error condition that prevents the HP All-in-One from printing the faxes (for
example, if the HP All-in-One runs out of paper). The HP All-in-One will continue
to store incoming faxes as long as there is memory available. (If the memory
User Guide 95
Fax