AMX Modero NXD/NXT-1200VG - Manual (Page 187)

Displaying Stream Content
173 VG-Series Modero Touch Panels
It is recommended that this value not currently be used by another port on the target device.
It is recommended that the following ports also not be used: 21, 22, 23, 80, 443, and 1319.
 For the purposes of these procedures, we’ve chosen to use 5000 as the video Target Port.
13. If using RTP as a Transport Protocol, enter a value into the Target Audio Port field. This field corresponds
to the port on the destination device where the audio only portion of the stream is being directed to. This
value can not match the value entered into the Target Port field above.
If using UDP as a Transport Protocol, this field becomes greyed-out and unused since the both the audio
and video content is being combined into a single stream.
 For the purposes of these procedures, we are not required to enter a Target Audio Port value
because the A/V content is not begin streamed separately (FIG. 135).
14. Click the Apply button to save the encoding profiles to the MAX-CSE.
Step 3: Configuring the MAX-CSE audio/video inputs
1. Complete the MAX-CSE connection and wiring procedures outlined within the Wiring the MAX-CSE
connectors and cables section of the MAX-CSE Instruction Manual.
2. Access the A/V Setup page (FIG. 136) by clicking the A/V Setup link from within the Navigation frame.
This page provides the user with the ability to select the source of the incoming video signal (from either
the rear Composite or S-Video port), the format of the incoming video (NTSC/PAL), and the gain given
to the incoming audio signal.
FIG. 135 Stream Profiles page (showing a sample configuration)
These port values must use
even numbers
If using RTP, both the Target Port and Target Audio Port must be different and
should use even numbers.