AMX Modero NXD/NXT-1200VG - Manual (Page 55)

Touch Panel Accessories
41 VG-Series Modero Touch Panels
4. Carefully place the Modero panel over the base alignment pegs (FIG. 28 and FIG. 29).
5. Gently apply downward pressure until the panel is securely mounted to the battery base (FIG. 29).
6. Firmly grip both the panel (from the side) and battery base (from below) together.
7. Gently place the touch panel LCD facedown onto a soft cloth (this prevents scratching of the LCD while
the battery base is being secured).
8. Locate the captive fasteners on the underside of the battery base by angling the base combo slightly
forwards.
FIG. 28 NXA-BASE/B showing Panel Interface and connector locations
Panel Interface
Battery Compartment
pulls outwards
connector (female)
Alignment
pegs
Captive fasteners
(secure base to
panel)
The battery base cannot be "hot-swapped". A panel receiving power through a
connected 12 VDC-compliant power supply cannot have a battery base installed onto
the bottom of the panel while powered. POWER OFF the panel before installing the
NXA-BASE/B.
"Hot swapping" could damage the base and cause it not to be recognized by the
panel.
FIG. 29 NXA-BASE/B shown aligning with NXT panel
Panel Interface
connector
Alignment
pegs
Interface
connector
Captive
fasteners
(male)
Top view Bottom view
(female)