Smittybilt 2763 Rear Storage Vault - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Rear Storage Vault
07-12 Wrangler & Unlimited
Part # 2763
Parts Included Qty Parts Included Qty
Storage Box 1 5/16” Flat Washer 6
“L” Bracket 3 ¼” x 1 ¼’ Self Tapping Screw 10
5/16” Hex Bolt 3 ¼” Flat Washer 10
5/16” Nut 3
Note: If installing in a 2 door JK you will need to remove the rear seat from the vehicle. Due to variations
between models and different manufacture options, mounting is not the same in all vehicles. The Storage
Vault can be securely mounted in various ways, using the “L” brackets or box base mounting holes or a
combination of both. It is recommended to mount using 4 mounting points but the option is yours.
Step 1: The storage vault will cover the rear oem storage area. If you have anything inside it, remove now.
(Fig A) You will also need to remove your floor jack. Your new storage vault is the perfect place to store it!
NOTE: If you do not want to drill and permanently secure your box, simply slide drawer back into box and
you are done.
Step 2: Remove the drawer from the box completely. Pull the drawer out and release side locking clamps.
(Push down on the left side (Fig B) and push up on the right side.) This will enable you to remove it.
(Fig A) (Fig B)
Step 3: Set the box in back of vehicle. (Fig C) Center the box as best as you can. Make sure box drawer will
not interfere with tailgate latch. (Fig D)
On 2-Doors push box back until its next to the rear oem seat bracket (Fig E)
On 4-Doors push box back approx. one inch in front of the oem strap brackets. ( Fig F)
Read instructions entirely before installing and using this part. Drilling is required to install this part.