Smittybilt 98702xx Replacement Top - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Replacement Top (Part # 98702xx)
1987-1995 Jeep Wrangler
Step 1: In order to install this top you must have the complete factory bow assembly and hardware on your
vehicle. If there is a top on your vehicle remove it at this time leaving all hardware on vehicle.
Step 2: With the rear spreader bar pulled down (Fig A) carefully lay your new top over the bow assembly.
Slide the front plastic channel on the top into the windshield header on top of your windshield frame. (Fig B)
(Fig A) (Fig B)
Step 3: Attach the snaps on the top to the center and rear bow assembly. (Fig C)
(Fig C) (Fig D)
NOTE: Read entire instructions thoroughly before installing this product. It is recommended to install this Top
when temperatures are above 70 degrees. If the Top has any wrinkles this is caused from packaging but once
the top relaxes they will go away. You must have the factory bow assembly in order to install this product.
Insert channel on front of top into your factory
windshield header.
To make installation easier pull down your
rear spreader bars and slide the rear bow
slightly forward.