Smittybilt 519801 Hardtop (1-piece) User Manual

Installation instructions, 06 jeep hardtop (1-piece)

Advertising
background image

WWW.SMITTYBILT.COM

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

97-06 Jeep Hardtop (1-piece)

Part # 519701 (without doors)

Part # 519801 (with doors)


Top Parts Included Qty

Door Parts Included Qty

Hardtop 1

Passenger Upper Door (if ordered) 1

Rear Window 1

Driver Upper Door (if ordered) 1

Weather Stripping 2

Compression Nut 6

5/16 x 1” Phillips Head Bolt 6

4” Truss Head Bolt 2

3/8 Flat Washer 6

5” Truss Head Bolt 4

5/16 Nut Plate 6

Armrest 2

This accessory is designed and manufactured primarily to augment the vehicles appearance

and to protect the occupants from normal weather conditions. This product is not designed to
protect occupants from injury or death in the event of an accident. Always wear your seat belt.

Step 1: If equipped remove softop and all hardware. (Fig A) If your vehicle has the molded rubber seal on
top of the belt rail located right behind each door; remove it as well.


Step 2: With assistance carefully set hardtop on vehicle; setting the back side edge on the vehicles belt rail
and the front on top of the windshield frame. (Fig B) Center top on vehicle.

(Fig A) (Fig B)

NOTE: Carefully read entire instructions thoroughly before attempting to assemble and/or
install this product.

With assistance
carefully set hardtop
on vehicle; setting
the back side edge
on the

vehicles belt

rail

If equipped
remove softop and
all hardware.

If your vehicle has the molded rubber
seal on top of the belt rail located right

behind each door; remove it as well.

Advertising
This manual is related to the following products: