Smittybilt Neoprene Seat Covers - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Neoprene Seat Covers
Step 1: Remove covers from box and place top (back section) loosely over the seat. (Fig A)
Note: Depending on your particular make or model there may be some slots/holes/flaps for
various features the seat uses.
Example: (TJ) Has a slot on the outer edge for the seat pull strap and/or a hole in the bottom left
corner for the seat tilt lever.
(JK) Has slots on the side for airbags, if your vehicle does not have airbags, simply
tuck the flap into the seat cover.
Step 2: Pull cover down over seat and insert front flap pushing through the middle of the seat.(Space
between the top and bottom portions of the seat.) Pull flap through the space and tuck under the
the back section of the seat cover. Fasten the Velcro together to hold in place. (Fig B)
Note: On some JK’s you will need to tuck up the flap on the bottom of the OEM cover into
the new neoprene cover. There will also be two holes on the top of the cover that you carefully
pull over the plastic headrest sleeves on the top of the seat.
Note: Please read instructions thoroughly before installing this product. Some pictures
and steps may vary depending on the year of the vehicle. These instructions are intended
to help with the installation process on all models.
Fig A Fig B
Slide top back section
of seat cover over seat. Push the front flap through the center of the seat and
fasten to the Velcro on the inside of the back bottom
portion of the cover.