Smittybilt 76634 XRC Side Armor/Rocker Guards - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
XRC Side Armor/Rocker Guards
Part # 76634, 76644
07-09 Jeep (Unlimited) 4-Door
Parts Included Qty
Driver Side Bar 1
Passenger Side Bar 1
STEP 1: Identify the Driver and the passenger side. The shorter end goes towards the front. (Fig A)
STEP 2: Remove the two side nuts from the front and rear body mount area. (Fig B)
STEP 3: Install the guard on the vehicle by placing the cut-outs in the top of the brackets around the body
mounts while lining up the two holes in the top of the brackets with the bolts you previously
removed the nuts from. (Fig C)
(Fig A) (Fig B)
(Fig C) (Fig D)
NOTE: Please read instructions entirely before installing product. It is recommended to have
assistance while installing this product.
Driver side shown. The shorter end goes
towards the front of the vehicle. Remove the two outer nuts from the front
and rear body mounts.
The top ‘U’ cut-
out goes around
the body mount The two studs that you
removed the nuts from
go through the two slots
in top of the bracket.