Smittybilt JN48-S2 Sure-Step - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 1600 Walnut Parkway, Rancho Dominguez, CA 90220
Installation Instructions
Sure-Step (Part # JN48-S2)
07 Jeep Wrangler JK 2 Door
PARTS LIST
2
Side bars 4 10MM lock washers
8 8MM X 20MM bolts 4 10MM X 25MM Hex bolts
8 8MM flat washers 6 6MM Button head bolts Phillips
8 8MM lock washers 12 6MM Fender washers
4 10MM nut plates 6 6MM lock nuts
4 10MM flat washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Locate, remove and set aside the four support brackets. Each is marked to identify their relative
location on the car. (Fig 1 and 2)
3. Locate and peel back the thin foam adhesive tape glued over the openings in the sub-frame openings
dedicated by the factory for the side bar installation. (Fig 3)
4. Install the nut plate with the nut facing upwards. (Fig 4)
5. Attach the bracket with one of the 10MM bolts furnished in the hardware kit and leave loose to allow
for adjustment. (Fig 5)
6. Attach the second bracket with one of the 10MM bolts furnished in the hardware kit and leave loose to
allow for adjustment.
7. Install the Phillips head screws, washers and locking nuts into the sides of the brackets and leave
loose. Note that the front brackets have 2 holes dedicated to these bolts, and the rear ones have only
one. (Fig 6)
8. Position the appropriate bar onto the two brackets and install the four 8MM bolts, flat washers and
lock washers. Adjust the bars before tightening.
9. Repeat the process on the other side of the car and tighten all the fasteners.
Fig 1 Passenger side
brackets Fig 2 Driver side
brackets