Smittybilt DRB-8 Defender Rack Bracket - Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Defender Rack Bracket
Application-Universal
Part # DRB-6, DRB-8
Part # DRB-6
Parts Included Qty Parts Included Qty
Hardware Kit (DRB-6-HP)
U-Bolt Plate 18
Bracket (DRB-1) 6 ¼” Nut 36
¼” x 2 3/4” U-Bolt 12 ¼” Flat Washer 36
¼” x 1 3/4” U-Bolt 6
Part # DRB-8
Parts Included Qty Parts Included Qty
Hardware Kit (DRB-8-HP)
U-Bolt Plate 24
Bracket (DRB-1) 8 ¼” Nut 48
¼” x 2 3/4” U-Bolt 16 ¼” Flat Washer 48
¼” x 1 3/4” U-Bolt 8
Step 1: Position the Defender Rack on your OEM rack. Make sure its evenly spaced
side to side and front to back.
Step 2:
Slide the ¼” x 1 ¾” U-Bolts around and up through the Rack strut plates and secure
with the included ¼” hardware. (Fig A)
Step 3:
Place the included plates under the factory or aftermarket racks cross bars and
slide the ¼” x 2 ¾” U-Bolts over the racks bars and down through the plates
and secure with the included ¼” hardware. (Fig B)
Note:
Defender Roof Racks are rated for loads of no more than 150lbs. evenly distributed.
When carrying a spare tire, the tire should not exceed 33” diameter
Please read instructions entirely before installing this product. Drilling is
required to install this product.