Smittybilt 2800 Dual Battery Tray - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Dual Battery Tray (Part # 2800)
97-06 Jeep Wranglers
Parts Included Qty
Middle Tray (A) 1
Lower Tray (B) 1
Upper “U” Clamp 1
3/8”- 16 Nuts 4
3/8” x 11 “Threaded Rods 2
M8 x 25mm counter sunk bolt 2
1/4” x 1 ¾” bolt 2
STEP 1:
• Remove the factory/existing battery by first removing the terminals from the battery.
CAUTION: Do not let terminals/cables come into contact with any metallic parts.
• Remove the factory plastic hold down clamp on the front bottom portion of the battery.
• Remove the battery from the vehicle.
• You may now remove the factory battery tray and unclip the battery temperature sending
unit. (Provisions will need to be made for the sensor in order to avoid the check engine light
from coming on.) Fig A.
STEP 2:
• Install the lower battery tray using two of the original tray fasteners on the left (outside) of
the bracket.
• Use the two provided counter-sunk bolts to secure the right (inside) of the bracket. Fig B.
• NOTE: the factory nut-clips can be moved slightly to help align the holes in the bracket if
needed.
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
This Dual Battery Tray only accommodates OPTIMA brand batteries. It is recommended to
have the wiring portion of this product be done by a certified mechanic/installer. Use caution
and care while working with batteries and electrical components.
A
B