Smittybilt 2740 I-Rack - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Installation Instructions:
(Part # SB2740)
I-Rack
(Intelligent Racking System)
Revised 12.8.09
NOTE: Carefully read entire instructions thoroughly before
attempting to install this part.
Parts Included Qty
90-4249 Jack Mount Stud 2
90-5763 Wing Bolt 5 1/2”: Gas Can Mount 1
90-5765 1/2” Wing Nut: Jack Mount Stud 2
90-4251 Gas Can Upper Mount 1
93-5771 Gas Can Lower Mount 1
93-5774 I-Rack Main Body 1
93-5769 Stem Mount 1
90-5761 Wing Bolt 1 1/4”: Main Body 2
90-5767 Gas Can Retainer 1
90-2466 Jack Mount Stud Spacer 2
Parts Included Qty
90-6723 Hardware Pack: Jack & Gas Can 1
1/2” Hex Nut Gr. 8 6
1/2” Split Lock Washer 6
1/2” SAE Flat Washer 6
P1029 Hardware Pack: Jack Mount Stud 2
Cushion 2
Retainer 2
Nut 1
90-5777 Nut Plate: Main Body 1
90170A212 Quick Disconnect Pin 2
CAUTION!: Adding excessive weight to the tire carrier may cause failure.
Typical Final Installation
NOTE: If your installation requires multiple gas can mounts, an additional gas can
mounting kit (SB2740-01) can be purchased separately.