JUMO 705060 mTRON T - Multifunction Panel 840 Operating Manual - Manual (Page 204)

14 Configuration – in setup program only
204
➥ The parameter can be configured. The settings are significant for the input mask in the user
area.
14.1.1 Configuring parameters
Setup dialog
Parameter
Parameter Selection/settings Description
Parameter Select the module and – in the selector
below – the process value or configura-
tion parameter. List of all process values and configura-
tion parameters of the entire system
The process values are to be selected
from the central processing unit or the
multifunction panel; the configuration
parameter is to be selected from the
module in question. The selected pro-
cess value or configuration parameter is
available in the user area.
Name Use the preset name or touch the ">"
button to enter a different name. Name of the parameter in the user area
The preset name corresponds to the
designation of the process value or con-
figuration parameter in the list.
Limit value min. Adopt the preset value or enter a differ-
ent value. Minimum admissible value for entry in
the user area
The preset value corresponds to the
smallest configurable limit and depends
on the data type of the process value or
configuration parameter.
Limit value max. Adopt the preset value or enter a differ-
ent value. Maximum admissible value for entry in
the user area
The preset value corresponds to the
largest configurable limit and depends
on the data type of the process value or
configuration parameter.