Lenze E84AVSCx 8400 StateLine C - Manual (Page 62)

8 Adapting the application individually
8.3 Implementing more additional functions in the signal flow
62
Lenze · 8400 StateLine · Operating instructions · from Firmware V06.00 · DMS 1.2 EN · 12/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.3 Implementing more additional functions in the signal flow
The pre-assignment of the application can be reconfigured via configuration parameters. Thus,
additional functions can be implemented in the signal flow as well.
Please observe the "source/destination principle" in this connection:
• A device input terminal can be linked to several input interfaces of the application.
• Each input interface of the application can only be linked to one input signal.
• An output interface of the application can be linked to several device output terminals.
The following subchapter " Pre-assignment of the input and output interfaces " shows in detail the
configuration parameters for the "actuating drive speed" application.
$SSOLNDWLRQ
$QWULHEVVFKQLWWVWHOOH
,QSXWV
,QSXWSRUWV 2XWSXWSRUWV

$SSOLFDWLRQ
'LJLWDOLQSXWV 'LJLWDORXWSXWV
$QDORJLQSXWV
,QSXWV
2XWSXWV
$QDORJRXWSXWV
& &
& &