Lenze E82EV 8200 vector 15kW-90kW - Manual (Page 141)

Electrical installation
Wiring
Wiring terminal strips
5
l
141 EDK82EV903 DE/EN/FR 5.1
5.2.2 Wiring terminal strips
The supplied terminal strips are tested according to the specifications of
ƒ DIN VDE 0627:1986−06 (partially)
ƒ DIN EN 60999:1994−04 (partially)
Checked and tested are, for instance, mechanical, electrical and thermal load, vibration,
damage of conductors, loose conductors, corrosion, ageing.
(
Stop!
Proceed as follows to avoid damage of the terminal strip and the contacts:
ƒ Mount or remove only when the controller is not connected to the mains!
ƒ Wire the terminal strips before connecting them!
ƒ Unused terminal strips must also be plugged in to protect the contacts.
8200vec015
)
Note!
Basically wiring without wire end ferrules is possible.
If safety functions (e.g. "Safe torque off") are used, insulated wire end ferrules
or rigid conductors are required!
5.2.3 EMC−compliant wiring
(Design of a CE−typical drive system)
)
Note!
ƒ Control cables and mains cables must be separated from the motor cable to
avoid interferences.
ƒ Control cable must always be shielded.
ƒ We recommend to shield the supply cable for the PTC or thermal contact
and route it separately from the motor cable.