Lenze E94AxHE Technology Application Synchronism - Manual (Page 21)

EDS94TA10040xxxx EN 1.1 - 10/2008
L
21
9400 Technology applications | Synchronism with mark synchronisation
Parameter setting & configuration
4 Parameter setting & configuration
Note!
The electrical shaft can be implemented with a bus system such as system bus
(CAN) or Ethernet Powerlink or via digital frequency transmission.
With regard to the configuration of the digital frequency extension module in
the controller, two variants of technology applications are available in the
»Engineer« application catalog.
• In the TA variant "Synchronism with mark synchronisation" the configuration
of a digital frequency extension module is expected. Therefore, the TA can
provide the function of the electrical shaft either via digital frequency
transmission and via a bus system.
• In the TA variant "Synchronism with mark synchronisation MotionBus" the
configuration of a digital frequency extension module is not included and
corresponding interfaces are not available in the TA. Thus the function of the
electrical shaft with this TA can only be provided via a bus system.