Yamato Scientific HC200 Cool Block - Manual (Page 43)

41
Indication after Step/Step Procedure Explanation
Setting Segment 2
10. Push the ENTER key
Ex. inputting a constant ratio ramp operation.
•
Push the ENTER key.
The controller turns to the program input mode for
.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key accepts the parameters of
Segment 1 and activates the input mode of Segment
2.
⇒ ⇒ ⇒ ⇒ The main display flashes (Segment 2),
indicating that the controller is ready for input of
Segment 2.
⇒ ⇒ ⇒ ⇒ On the sub display, the left two digits show the
program number that you are working on and the
right two digits show the number of available
segments.
11. Push the ENTER key
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The sub display shows requesting for input
of the Ramp Time 2.
⇒ ⇒ ⇒ ⇒ The main display flashes .
! In Figure 4, Segment 2 is designed for the step
operation. Set a desired value in the same manner
as Segment 1.
In the same manner as Segment 1, input the ramp time, ramp level, soak time and wait function.
12. Push the ENTER key after selecting a value
by the ▼ key or the ▲key.
(Ex. inputting 1 hour)
•
After selecting your desired value by pushing the ▼
key or the ▲key, push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key sets the Ramp Time 2.
13. Push the ENTER key after selecting a value
by the ▼ key or the ▲key.
(Ex. inputting 60 ℃)
•
After selecting your desired value by pushing the ▼
key or the ▲key, push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key sets the Ramp Level 2.
14. Push the ENTER key after selecting a value
by the ▼ key or the ▲key.
(Ex. inputting 30 minutes)
•
After selecting your desired value by pushing the ▼
key or the ▲key, push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key sets the Soak time 2.
15. Push the ENTER key after selecting a value
by the ▼ key or the ▲key.
(Ex. turning ON the wait function)
•
After selecting On of the wait function by pushing the
▼ key or the ▲key, push the ENTER key.
⇒ ⇒ ⇒ ⇒ Pushing the ENTER key turns on the wait function of
Segment 2.
(The number of unused segments)
(Ramp time of Segment 2)
(The program number
that you are working on.)